atyfb 0000:00:0d.0: PCI INT A -> Link[LNKA] -> GSI 9 (level, low) -> IRQ 9
atyfb: using auxiliary register aperture
atyfb: 3D RAGE Mobility P/M (Mach64 LR, PCI) [ox4c52 rev 0x64]
atyfb: Mach64 BIOS is located at c0000, mapped at c00c0000.
atyfb: BIOS frequency table:
atyfb: PCLK_min_freq 984, PCLK_max_freq 23600, ref_freq 2950, ref_divider 64
atyfb: MCLK_pwd 4200, MCLK_max_freq 8300, XCLK_max_freq 12500, SCLK_freq 5000
atyfb: BIOS contains driver information table.
atyfb: colour active matrix monitor detected: Sharp
atyfb: id=1, 1024x480 pixels, 262144 colours (LT mode)
atyfb: supports refresh rates [60], default 60 Hz
atyfb: LCD CDTC parameters: 42.8044 1024 1048 1184 1344 480 489 495 525
atyfb: : 23618 160 1024 24 136 30 480 9 6
atyfb: 8M SDRAM (1:1), 29.498928 Mhz XTAL, 236 Mhz PLL, 83 Mhz MCLK 125 Mhz XCLK
Console: switching to colour frame buffer device 80x30
atyfb: fb0: ATY Mach64 frame buffer device on PCI
was mir grad beim abtippen noch aufgefallen ist:
In den ganzen alten tutorials war immer von einer 128x30 console die Rede und hier sehe ich, dass es 80x30 ist. Vielleicht hilft es das irgendwie zu ändern?
wenn ja, wie geht das?
aber wenigstens wird nun schonmal der ganze Bildschirm genutzt 😃