Hallo archlinuxusers,
die WLAN-Verbindung mittels NetworkManager funktioniert nicht. (
https://wiki.archlinux.org/index.php/NetworkManager)
Ich habe die Xfce-Oberfläche installiert.
Wenn ich in mittels
sudo systemctl restart NetworkManager.service
starte/restarte, dann listet
rfkill list
0: samsung-wlan: Wireless LAN
Soft blocked: yes
Hard blocked: no
1: phy0: Wireless LAN
Soft blocked: yes
Hard blocked: yes
Nach
sudo rfkill unblock wifi
wird zwar alles auf
no gesetzt, dennoch erscheint im grafischen nm-applet:
Funknetzwerk ist deaktiviert
Die einzige Möglichkeit mit WLAN zu verbinden ist es, den NetworkManager zu deaktivieren und das wifi-menu zu verwenden, aber eigentlich würde ich gerne den NetworkManager verwenden.
lspci -v
02:00.0 Network controller: Qualcomm Atheros AR9285 Wireless Network Adapter (PCI-Express) (rev 01)
Subsystem: Samsung Electronics Co Ltd Device 4101
Flags: bus master, fast devsel, latency 0, IRQ 16
Memory at f3200000 (64-bit, non-prefetchable) [size=64K]
Capabilities: <access denied>
Kernel driver in use: ath9k
Kernel modules: ath9k
ip link
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: enp3s0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc fq_codel state DOWN mode DEFAULT group default qlen 1000
link/ether e8:11:32:4e:b7:f6 brd ff:ff:ff:ff:ff:ff
3: wlp2s0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP mode DORMANT group default qlen 1000
link/ether 9e:aa:2a:c5:d6:64 brd ff:ff:ff:ff:ff:ff
iw dev wlp2s0 scan
BSS bc:05:43:fb:7e:79(on wlp2s0) -- associated
TSF: 146459382912 usec (1d, 16:40:59)
freq: 2412
beacon interval: 100 TUs
capability: ESS Privacy ShortPreamble ShortSlotTime (0x0431)
signal: -47.00 dBm
last seen: 210 ms ago
Information elements from Probe Response frame:
SSID: WLAN
Supported rates: 1.0* 2.0* 5.5* 11.0* 6.0 9.0 12.0 18.0
DS Parameter set: channel 1
RSN: * Version: 1
* Group cipher: TKIP
* Pairwise ciphers: CCMP
* Authentication suites: PSK
* Capabilities: 1-PTKSA-RC 1-GTKSA-RC (0x0000)
WPA: * Version: 1
* Group cipher: TKIP
* Pairwise ciphers: TKIP
* Authentication suites: PSK
ERP: <no flags>
Extended supported rates: 24.0 36.0 48.0 54.0
WMM: * Parameter version 1
* u-APSD
* BE: CW 15-1023, AIFSN 3
* BK: CW 15-1023, AIFSN 7
* VI: CW 7-15, AIFSN 2, TXOP 3008 usec
* VO: CW 3-7, AIFSN 2, TXOP 1504 usec
HT capabilities:
Capabilities: 0x13ce
HT20/HT40
SM Power Save disabled
RX HT40 SGI
TX STBC
RX STBC 3-streams
Max AMSDU length: 3839 bytes
DSSS/CCK HT40
Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
Minimum RX AMPDU time spacing: 8 usec (0x06)
HT RX MCS rate indexes supported: 0-7
HT TX MCS rate indexes are undefined
HT operation:
* primary channel: 1
* secondary channel offset: above
* STA channel width: any
* RIFS: 1
* HT protection: 20 MHz
* non-GF present: 0
* OBSS non-GF present: 0
* dual beacon: 0
* dual CTS protection: 0
* STBC beacon: 0
* L-SIG TXOP Prot: 0
* PCO active: 0
* PCO phase: 0
WPS: * Version: 1.0
* Wi-Fi Protected Setup State: 2 (Configured)
* Response Type: 0
* UUID: ec682788-e7aa-7270-2469-fb4305bc797e
* Manufacturer: AVM
* Model: FRITZ!Box
* Model Number: 0000
* Serial Number: 0000
* Primary Device Type: 6-0050f204-1
* Device name: FBox
* Config methods: Display, PBC, Keypad
* RF Bands: 0x3
Warum ist das Funknetzwerk deaktiviert, wenn ich den NetworkManager gestartet habe?
Viele Grüße und danke im Voraus!