Hallo,
ich habe einen Intel SS4200-EHW Server.
Der Rechner hat einen ICH7 Chipsatz.
lspci:
00:00.0 Host bridge: Intel Corporation 82945G/GZ/P/PL Memory Controller Hub (rev 02)
00:1c.0 PCI bridge: Intel Corporation 82801G (ICH7 Family) PCI Express Port 1 (rev 01)
00:1d.0 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI Controller #1 (rev 01)
00:1d.1 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI Controller #2 (rev 01)
00:1d.2 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI Controller #3 (rev 01)
00:1d.3 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI Controller #4 (rev 01)
00:1d.7 USB Controller: Intel Corporation 82801G (ICH7 Family) USB2 EHCI Controller (rev 01)
00:1e.0 PCI bridge: Intel Corporation 82801 PCI Bridge (rev e1)
00:1f.0 ISA bridge: Intel Corporation 82801GB/GR (ICH7 Family) LPC Interface Bridge (rev 01)
00:1f.2 IDE interface: Intel Corporation 82801GB/GR/GH (ICH7 Family) SATA IDE Controller (rev 01)
00:1f.3 SMBus: Intel Corporation 82801G (ICH7 Family) SMBus Controller (rev 01)
01:00.0 Ethernet controller: Intel Corporation 82573V Gigabit Ethernet Controller (Copper) (rev 03)
Das Gerät hat 4 SATA Ports und einen IDE-Anschluss.
Im Bios werden alle Platten auch sauber erkannt.
Nur leider nachd dem booten wird keine Platte am IDE-Anschluss mehr erkannt.
Irgendwie hat es mit den geladenen Modulen zu tun.
Geladen werden ata_piix, ata_generic, pata_acpi und libata.
Sobald ich das ide_generic Modul von Hand nachlade, wird sofort die Platte am IDE-Anschluss erkannt und ist als /dev/hda erreichbar.
Allerdings wollte ich das alte Modul eigentlich nicht gerne nutzen.
Gibt es eine Möglichgkeit die neuen Libata-Module dazu zu bewegen, eine Platte am IDE-Port des ICH7 zu erkennen?